SERVICES / FABRICATION / ROLL CAGES AND BARS A roll bar designed and installed in a SCCA Solo1 1972 Datsun 240Z. 1.5" OD .120 DOM tubing for the SCCA mandated bars and 1.5" OD .095 wall DOM tubing for the shoulder bar and strut tower brace. As you can see in the pictures this car was also seam welded throughout and had the floor pans and rocker panels replaced.
Miata ITA cage - pre-bend cage tubing and mounting plates supplied by Sean at MiataCage.com. This Miata is a magazine project car for SportsCar. You'll see it in a future issue.
Simpel roll cage for a 1982 Toyota Corolla. This car was entered by Road and Track Magazine in the first 24 Hours of LeMons race - and won! Read the Road and Track article about the event here. We had to buld the cage in a day so we used the templates from a Datsun 240Z abd basiclaly extended the tubes where we needed to.
We can also install bolt-in bars and cages like the Autopower cage installed in a Spec944 Porsche below:
Cage updates on a vintage racing Datun 240Z.
Kirk Racing bolt-in roll bar for the S30 chassis:
|
|
|
